Milwaukee Negative Rake 190mm 40T Circular Mitre Saw Blade 30mm Bore

The Milwaukee Negative Rake Circular Mitre Saw Blade is a 190mm blade with 40 teeth and a 30mm bore. It suits smaller mitre saws used for timber framing, joinery and general carpentry on site. The range runs from 190mm up to 305mm, so check your saw's blade size first.

The negative rake design gives controlled and safer cutting in a mitre saw. Forty teeth strike a balance between speed and finish. That makes it a practical all-rounder for crosscutting softwood and hardwood sections. The teeth are cobalt-infused tungsten carbide, so the edge stays sharp through repeated use.

A non-stick PTFE coating fights resin build-up and corrosion. The blade runs cooler and cuts faster over a long job. Laser-cut slots filled with polyurethane cut vibration and noise. Less vibration means better accuracy. The steel body is laser cut to hold its shape.

Who is it for? Tradespeople who want a coated blade with low vibration, clean crosscuts and long lasting teeth. Milwaukee backs it with a manufacturer warranty against defects.

A negative rake angle leans the tooth face back from the cut. On a mitre saw this stops the blade grabbing the timber and lifting the workpiece. With 40 teeth you get a fine enough finish for visible joints while still cutting at a good pace. The PTFE coating cuts friction so resin does not bake onto the plate. Polyurethane in the laser-cut slots soaks up vibration. In use that means a quieter cut with less chatter on the edge.

Unplug or remove the battery before fitting the blade. Check that the 190mm diameter and 30mm bore match your saw. Fit it with the teeth facing the direction of rotation shown on the blade. Clamp the workpiece and keep hands clear of the cut line. Wear eye and ear protection and use the saw's guard and dust extraction.